How to remove water from diesel generator oil?

As we all know, oil is the driving raw material of diesel generator set. Most diesel generator sets have high quality requirements for oil. If the diesel oil is mixed with water, the light will lead to the unit can not operate normally, the heavy will lead to the generator internal short circuit, equipment failure, then the diesel generator oil how to remove water?

First of all, the user can put the oil in the test tube heating, if there is a slight water sound in the oil, and can observe the blisters, indicating that there is water in the oil, this time you can use the boiling point of the oil and water is different to deal with, continue to heat until the blisters disappear, the water is completely restored, and then the gasoline cooling to normal temperature continue to use.

Secondly, if the oil has been emulsified, you can add 1% to 3% of the oil weight phenol (carbonic acid) to the oil as a deemulsifier, stir while adding, and then preheat the oil for a period of time, and wait for the water and oil stratification after. Remove the moisture from the oil thoroughly.

Once again, the instrument can be used to remove the water in the diesel generator set, the emulsified oil is poured into the serpentine heating tube, and the saturated steam is used to stop the heating through the serpentine tube. At the same time, air is passed into the instrument to make the moisture in the oil volatilize. Then the oil is cooled so that the oil can be used normally.

How to remove water from diesel generator oil? This is the end of the introduction of wing power, thank you for reading.